사출 성형 스마트 펙트리 시스템에서 제습 건조기를 위한 인터페이스 모듈

When the injection molding system molds some plastic products, defective product rate will be increased if plastic materials have some excessive moisture content. Therefore, it is very important to control the dehumidification and drying of plastic material. Since the moisture content of the plastic...

Full description

Saved in:
Bibliographic Details
Published in한국컴퓨터정보학회논문지 Vol. 23; no. 11; pp. 123 - 128
Main Author 강운구(Un-Gu Kang)
Format Journal Article
LanguageKorean
Published 한국컴퓨터정보학회 01.11.2018
Subjects
컴퓨터학
Realtime humidity monitoring system
Injection molding
Dehumidify dryer
Smart factory
IoT
Online AccessGet full text
ISSN1598-849X
2383-9945
DOI10.9708/jksci.2018.23.11.123

Cover

More Information
Summary:When the injection molding system molds some plastic products, defective product rate will be increased if plastic materials have some excessive moisture content. Therefore, it is very important to control the dehumidification and drying of plastic material. Since the moisture content of the plastic material may change from time to time depending on the material and the molding process, it is necessary to observe the change in real time and maintain a constant moisture content. To solve these problems, I proposed a smart factory system model for plastic molding in this paper. In addition, I designed the interface module to be installed in the dehumidifying dryer which is the core of this process. In addition to this, performance tests were conducted to check the effectiveness and the results were verified as valid. KCI Citation Count: 0
ISSN:1598-849X
2383-9945
DOI:10.9708/jksci.2018.23.11.123