Reverse Engineering Design Of Ceiling Lamp Changer To Increase Product Value By Using Dfma Methode

• Published in: Jurnal Syntax Transformation Vol. 6; no. 6; pp. 165 - 177
• Main Authors: Pranoto, Bayu, Weddakarti, Eva, Perkasa, Rilis Eka, Ekasari, Silvia Rahmi, Supriyanto, Nicky Suwandhy Widhi
• Format: Journal Article
• Language: English
• Published: 20.06.2025
• ISSN: 2721-3854; 2721-2769; 2721-2769
• DOI: 10.46799/jst.v6i6.1083

Often we see people replacing ceiling lights by climbing on tables or cabinets to reach the light at a certain height, then removing and replacing it by hand. This method carries a high risk of injury to the person. Imagine if, while the person was replacing the light, they accidentally slipped and fell from the cabinet or table they were using as a support, not to mention if there was a mistake when installing the light and a short circuit occurred, and the person was electrocuted. These possibilities of injury would be very fatal if not carefully considered. In response to this problem, it is necessary to develop the ceiling lamp changer that already exists in society, which will later be upgraded from manual to semi-automatic. Semi-automatic here refers to the use of a control switch to rotate the lamp holder, so that the process of replacing (removing and installing) the lamp becomes faster, safer, and easier. With the planning of a semi-automatic ceiling lamp replacement tool, it is hoped that it can be accepted by the community. In this case, product cost planning and selling price determination will also be made so that it is affordable with the market.