CFD simulation and experimental comparison of bubble-induced convection during electrochemical water splitting

• Published in: Chemical engineering journal (Lausanne, Switzerland : 1996) Vol. 433; p. 133194
• Main Authors: Wosiak, Gabriel, da Silva, Jeyse, Sena, Sthefany S., de Andrade, Renato N., Pereira, Ernesto
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 01.04.2022
• Subjects: Electrolysis; Finite element simulation; Hydrogen; Water splitting; Water splitting; Electrolysis; Hydrogen; Finite element simulation
• ISSN: 1385-8947; 1873-3212
• DOI: 10.1016/j.cej.2021.133194

The behavior of gas bubbles produced during electrochemical processes is of large interest because of the increase in cell overpotential induced by their production, the electrode surface covering by them and, finally, the detachment of these bubbles and their direct impact on the energy consumption during the reaction. In this work, we used coupled experimental and computational approaches to investigate bubble formation under those conditions where there are important convective effects. We have measured both normal and parallel velocity of the solution and built up a computational fluid dynamics (CFD) model. The results were compared to experimental data. Then, having the computational model validated by experimental data, we have simulated different conditions following bubble displacement. An important change of the surface covering is observed during the electrochemical reaction. Considering just the covering change, for example, there is up to 23 % increase comparing to the electrode edge and center. [Display omitted] •Finite element method is suitable to evaluate the bubble-induced convection.•The bubbles create a vortex in the electrolyte.•The induced convection create a non-homogeneous gas covering over electrode surface.•The bubble size has an important effect in the covering variance.